Designed to interactively detect and optimize your electricity loads so as to eliminate energy wastage

SAVING
• Saves monthly electricity consumption up to 40% of normal bill
• Improves Power Factor results in increased electrical efficiency
• Extends the life span of electrical appliances

SAFETY
• 100% Passed die-electric withstanding voltage and insulation resistance test
• Built-in lightning arrestor and voltage surge protector (stabilize current)
• Reduces Wire temperature and limits fire hazards
• Built-in Low Pass Filter to eliminates electrical noises
• 100% Rohs Compliance
• Type of material used - Fire retardant (UL94V0)

APPROVAL STANDARD
• Manufactured by an ISO9001 / 14001 Certified Company
• Product and Components conforming to International Standards & Local Approving Statutory Bodies for Safety, Performance & Reliability (SIRIM, TUV, UL etc)

USER FRIENDLY
• Easy Installation & 100% maintenance FREE
• 1 unit for entire house for single phase and 3 units
for 3 phase

SALES & SERVICE
• Strong after sales service support
• Customer care centre / help desk

WORKING PRINCIPLES
• Eco Energy Saver converts an alternating current coming from the main into a stabilized alternating current
• The low pass filter smoothen the incoming current so as to reduce noise and improves efficiency
• Eco Energy Saver will temporarily store excess energy due to surges and stabilize current at inductive load and releases the stored energy back into the system. This will help curbed electricity wastage, increasing the power factor and reducing the amount of re-active power that the inductive load draws from the incoming load.
• Eco Energy Saver will improve efficiency on the inductive load by reducing electricity consumption and preventing overheating resulting from electrical surges, this will help to prevent blowouts and power outages while prolonging life span of all wiring and appliances.

TYPICAL INCOMING LOAD
• Inefficiencies from power supplies such as occasional electric surges increases energy consumption and often leads to circuit over load.
• Constant voltage surges and dips in urban/ industrialized areas create an ineffective and inefficient transfer of power
• Use of poor quality electrical components in home appliances worsen the situation, reduces the power factor and consume more power
• Higher current and noise generates more heat and accelerates the wastage of energy
• In conclusion, owners consumes more power

FACTS & INFORMATION

WITHOUT ENERGY SAVER SITUATION
• There will always be high frequency voltage noise riding on the 50Hz sine wave
• Surge on both voltage and current
• Out of phase between current and voltage
• Reactive components will draw more current at lower PF (use of cheap appliances / poor quality)
• More heat generated (requires thick wire or else it may pose as a wire hazard)
• Energy lost due to continuous heat generated
• Poorer electrical performance on the appliances
• Lower the PF (low efficiency)
• Unprotected from electrical surge.

"NO SAVINGS" - POSSIBLE CAUSES
• The connection from TNB (fuse) is loose
• Components on the Distributor Board is loose
• 3 phase equipment deliberately running on single phase (overloading)
• Where PF is above 0.95
• Incoming supply is directly from sub-station
• Malfunctioning of air-conditioner, freezer and other appliances
• Condition of internal wiring
• The life wire is not fixed into the busbar or the output on the ELCB
• Eco Energy Saver is faulty
• Operative manner of equipment or home appliances

INSTALLATION GUIDE

SINGLE PHASE INSTALLATION

i)INSTALLATION DIAGRAM
ii)WIRING INSTALLATION

• Just plug into a 13A Socket nearest to the DB Board
• Do not use on an extension / multiple socket

THREE PHASE INSTALLATION

i)INSTALLATION DIAGRAM
ii)1ST PHASE WIRING INSTALLATION - RED

iii)2ND PHASE WIRING INSTALLATION - YELLOW
iv)3RD PHASE WIRING INSTALLATION - BLUE

NOTE : THE NEUTRAL & EARTH WIRES IS TO BE LOOPED ON EVERY PHASE.

This product hasn't been reviewed yet.